She is 37%. I am using the Schlunndt G62 Belt drive spinning a 34x20 prop. What is super cool is that the reduction actually spins the prop at scale speed, IE full throttle 2700rpm and It idles down to 5-600 rpm.

I covered here with Stits and dope, has ribstitching, tapes a few inspection rings. Paint is dope, about 6 coats, wet sanded, sprayed, wet sanded, sprayed etc. tail number is masked at and sprayed as well as the starburst and tail stripes. I was able to get the pilot from Twin Pilot in Germany, no, he is not my twin.

Dual Futaba RX, Dual Fromeco LiOn, 5200mahs each. I have each receiver controlling one half of the plane. I am using JR Servos all around.

I have a homemade smoke pump powered by an outrunner and a 1200mah 3S.

the instrument panels came from Aerocockpit, and I made some other bits and pieces with the use of a 3d printer.

She weighs 51lbs ready to fly.

I' ll be at Cen-Del WAC  Fredricksburg, Goshen, and Tullahoma if you'd like to see her fly.

At 51 lb what will it do, Big loops,?  Knife edge?

Just interested because i have been flying mine recently , 33% and 32 lb with Roto 85cc