I've been flying RC since 2008.  Built several Great Planes and Sig kits.  Then I tried my luck at designing a stick in 3D software, making a drawing and then building it.  Built a 1/2a airplane from plans which were slightly modified for an electric power system.  I used dope and silk span just to try something new.

Building has been replaced with assembling 3D ARFs for a while as I'm learning something new. Occasionally rescue airplanes from swap meets or trash bins. What ever's free just to satisfy my need to build something.

I was recently given a 1/4 scale Bub Nosen Mr Mulligan.  I mounted an engine, added servos and packing tape over holes in the covering.  I flew it a couple of times and decided to strip it down, repair it and make it look new again.

I have a few questions I post later.

Thanks

 

Welcome to RCSB.  This is a great place to ask questions and seek recommendations.  You will get a lot more out of this site if you become a paid member.  There is a lot of talent and brain power on this site.